Special enrollment Monday May 1 to Friday May 5, 2017

An Introduction to Compression: Basic Compression - A Free Guide from Audio Masterclass

An Introduction to Equalization - A Free Guide from Audio Masterclass

Equipping Your Home Recording Studio - A Free Guide from Audio Masterclass

Why active studio monitor loudspeakers should always sound better than passive speakers

A post by David Mellor
Wednesday January 11, 2006
Active loudspeakers separate the frequency bands before amplification. This should result in better sound quality than passive loudspeakers, where the crossover must work at much higher signal levels - but do the manufacturers always play 100% fair?
Why active studio monitor loudspeakers should always sound better than passive speakers

Most loudspeakers used in studio recording and domestic hi-fi are of the passive variety. This means that each channel of the power amplifier feeds high-level signal into each speaker enclosure. Inside the enclosure there is a passive crossover network consisting of resistors, capacitors and inductors that separates the signal into high frequencies (HF) which go to the tweeter, and low frequencies (LF) which go to the woofer. There may also be a midrange band.

The crossover is called 'passive' because it has no power supply and no means of amplifying the signal or any component of the signal.

Passive crossovers suffer from several problems:

  • They must work at high power. This means using large expensive components, hence manufacturers will tend to simplify the circuit as much as possible
  • Large inductors often have an iron core. This can saturate magnetically, causing distortion
  • In practical crossovers, the sum of the outputs of the frequency bands is not equivalent to the input signal, hence the sound quality is changed
  • The amplifier is electrically separated from the drive units, hence has less control over the motion of their diaphragms, particularly that of the woofer

An active loudspeaker can solve all of these problems. The signal from the mixing console is fed to an active crossover (which may be inside the speaker enclosure, meaning that the speaker has to be mains powered); the signal is split into frequency bands at low level, very accurately. Each band goes to a separate power amplifier, each of which is connected directly to a single drive unit.

The only apparent disadvantage of the active loudspeaker is that the need for multiple power amplifiers may mean that it is more expensive, but you don't need a separate power amplifier, so this will probably compensate.

However, it is not unknown for manufacturers to design so-called 'active' loudspeakers that are merely a passive loudspeaker with a single amplifier inside the box. This offers no advantage over conventional speakers.

The main reason why active loudspeakers are not more commonplace is that there is no separate power amplifier, and that means one less item for the manufacturer to market to eager buyers.

There is only one real disadvantage to active loudspeakers. This is in live sound where sometimes loudspeakers must be 'flown' (suspended). Obviously, an internal amplifier makes the speaker heavier, where with a passive system the amplifier could remain on the ground.

A post by David Mellor
Wednesday January 11, 2006 ARCHIVE
David Mellor has been creating music and recording in professional and home studios for more than 30 years. This website is all about learning how to improve and have more fun with music and recording. If you enjoy creating music and recording it, then you're definitely in the right place :-)