Equipping Your Home Recording Studio - A Free Guide from Audio Masterclass

An Introduction to Compression: Basic Compression - A Free Guide from Audio Masterclass

An Introduction to Equalization - A Free Guide from Audio Masterclass

What is a transient? Can it hurt me?

A post by David Mellor
Monday July 31, 2006
A transient is a sudden change in signal level. Can this harm a recording? What should an engineer do to accommodate transients?
What is a transient? Can it hurt me?
Learn Cubase

A transient event is something that comes and goes very quickly. In audio, it means a sudden increase in signal level followed by an almost immediate decrease. In terms of milliseconds, we would be thinking about less than a hundred, or a tenth of a second. Anything longer wouldn't really be worthy of being called a transient, although it is a similar judgment call to when a stream becomes a river.

A transient in audio can also be a sudden increase in level, followed by a steady-state high level signal. So in this case the signal isn't coming and going, but the sudden change in level is the transient.

A transient can hurt your recording in a number of ways...

  • If your meters are not fast enough, the transient may not be measured correctly. In this case you could easily push the level high enough to get distortion. You won't see any red lights, but you will hear a change in the sound.
  • A recording that is full of transients, if metered correctly, will sound subjectively quiet. This is because you will reduce the level to accommodate the transients properly, but then the bulk of the signal will be well below the full level your system can accommodate.
  • Severe transients can blow speakers. Dropping a mic connected to a PA system is a good example of something to avoid.

It is good practice therefore to manage transients consciously. That doesn't mean getting rid of them, just reducing their effect where appropriate. The tool to use is the compressor or limiter. If you set a fast attack time, then the transient will be brought down in level. However, this will also change the character of the transient, and the 'front end' of a sound is important to the way the ear hears. So you have to be careful and achieve a fine balance. If you use a slow attack time, the transient will get through unaltered, so you haven't achieved anything.

If you have just one or two significant transients in your recording, then it will be better to reduce their level using the editing facilities of your recording software. You will be a far better judge of what to do than the automatic action of a compressor.

A post by David Mellor
Monday July 31, 2006 ARCHIVE
David Mellor has been creating music and recording in professional and home studios for more than 30 years. This website is all about learning how to improve and have more fun with music and recording. If you enjoy creating music and recording it, then you're definitely in the right place :-)
Come on the FREE COURSE TOUR