An Introduction to Compression: Basic Compression - A Free Guide from Audio Masterclass

An Introduction to Equalization - A Free Guide from Audio Masterclass

Equipping Your Home Recording Studio - A Free Guide from Audio Masterclass

Noise gate side chain filters

A post by David Mellor
Tuesday March 04, 2003
The use of the side chain filters of the noise gate to achieve reliable gating.
Noise gate side chain filters
Learn Cubase

Basic gating is easy enough when the sound source is well differentiated between signal and noise.

But there are times when the noise is so high in level that setting the threshold to a point that fits neatly between the signal and the noise is impossible.

A good example would be the drum kit, particularly the snare drum and hihat. The snare and hihat are so close together that the snare mic will pick up as much level from the hihat as it does from its own instrument.

It will be impossible to set the threshold for correct gating.

The solution to this problem is found in the filter controls. Just like a compressor, a noise gate has a 'side chain' signal that is used to control the behavior of the processed signal.

In a gate, this is commonly called the trigger, or key signal. In normal use with the filters set to their end stop positions - so that they have no effect - the key signal is identical to the input signal. Indeed it is just tapped off from it.

To stop the hihat from opening the gate on the snare mic, simply filter out the high frequencies from the key. The snare is sufficiently rich in low frequencies that it will still open the gate, but the lesser LF content of the hihat is not enough to do the same.

If there was a mic on the hihat suffering from the same problem, then the low and mid frequencies could be filtered out of the key, and the rich high frequency energy of the hihat would still open the gate.

One important point to note is that the filters have no effect on the frequency balance of the output signal. They only affect the key, which once it has done its job goes nowhere.

There is a function, here called 'key listen' that switches the key signal to the output. This can be used for setting up the gate, then switched back to 'gate' for normal operation.

A post by David Mellor
Tuesday March 04, 2003 ARCHIVE
David Mellor has been creating music and recording in professional and home studios for more than 30 years. This website is all about learning how to improve and have more fun with music and recording. If you enjoy creating music and recording it, then you're definitely in the right place :-)
Come on the FREE COURSE TOUR