Equipping Your Home Recording Studio - A Free Guide from Audio Masterclass

An Introduction to Equalization - A Free Guide from Audio Masterclass

An Introduction to Compression: Basic Compression - A Free Guide from Audio Masterclass

If setting the gain correctly is so important, why don't mic preamplifiers have meters?

A post by David Mellor
Monday March 15, 2010
Setting the gain of the microphone preamplifier correctly is one of the basic skills of audio. So why don't mic preamps need meters?
If setting the gain correctly is so important, why don't mic preamplifiers have meters?

When you first learn how to use a mixing console, you will be shown how to set the gain. Your instructor - either in audio school or in the workplace - will emphasize the importance of this and kick your ass every time you get it wrong, until you can't do anything other than get it right.

Setting the gain correctly optimizes the signal level for further processing in the mixing console. EQ, inserts, auxiliary sends, routing, fading, solo and mixing all depend on having the right signal level for optimum performance, and the gain control is precisely where you set that.

But outboard microphone preamplifiers commonly only have rudimentary metering facilities - perhaps only a single 'clip' LED - or no metering at all! So how can you possibly set the gain correctly?

The answer is that firstly the preamplifier needs to be correctly designed with plenty of output level available. For example, the Manley Labs Mono and Dual Mono microphone preamplifiers can supply up to 30 dBV of output before clipping. That is one hell of a voltage in audio terms - around 30 volts, compared to a normal operating level of around one volt.

It's probably fair to say that the Manley Labs Mono can drive any line input effortlessly so there is no need for metering in the preamp.

Where you do need metering is in the equipment you are driving with the preamp, possibly your DAW. So a good procedure for setting the gain with the Manley preamp is to choose the lowest setting of gain, and also set the 'input attenuate' control to its lowest setting. Then reduce the amount of attenuation while watching the meter on your recorder. When you are getting a good, healthy signal level with a reasonable margin before clipping on your recording, you have the right settings.

If if the level from the mic is too low to reach a good indication on your recorder's meter, increase the gain as far as necessary but no further.

Setting the attenuator and gain controls in this way will optimize the noise and distortion performance of the preamp.

Now since this is a tube preamp with variable 'character' according to the gain setting chosen, then once you have mastered setting the gain in the technically correct way, you are free to break the rules and, if you wish, choose a high gain setting with more attenuation. This will give more of the tube sound.

A post by David Mellor
Monday March 15, 2010 ARCHIVE
David Mellor has been creating music and recording in professional and home studios for more than 30 years. This website is all about learning how to improve and have more fun with music and recording. If you enjoy creating music and recording it, then you're definitely in the right place :-)
Come on the FREE COURSE TOUR