An Introduction to Equalization - A Free Guide from Audio Masterclass

An Introduction to Compression: Basic Compression - A Free Guide from Audio Masterclass

Equipping Your Home Recording Studio - A Free Guide from Audio Masterclass

Do not press this button! If you do, you will be sorry!

A post by David Mellor
Friday November 11, 2005
'Do not press this button'. Was that the Hitchhiker's Guide to the Galaxy, or Red Dwarf? Or an item of sound engineering equipment close to you...?
Do not press this button! If you do, you will be sorry!

Imagine having a piece of sound engineering equipment with a button marked 'do not press'. Or worse still, two buttons labeled 'do not press'.

OK, in this instance, the label was scribbled by hand, but the exclamation mark more than hints at the severe consequences that will result should someone be so foolhardy as to ignore the warning.

The equipment in question is the original Spirit-by-Soundcraft Folio 12 into 2 portable mixing console. This was the first of the wave of small, inexpensive, but eminently usable consoles that soon followed.

You normally wouldn't expect Soundcraft to get anything wrong, but they sure did here.

The upper of the 'do not press' controls inserts a 1 kHz tone into the main stereo outputs. Yes, tones are good, and a console without an oscillator is like a dog without a woof.

The problem is that it is so close to the master faders. One slight slip and you have 1 kHz where all before was music. And it might be a pretty loud 1 kHz too.

The other button is more unusual. The console has a stereo tape return input for checking what you have just recorded. Once again, all good consoles should have one.

But often, the tape return isn't used, or can be considered a luxury that isn't altogether necessary. So this button allows the option to use the tape returns as additional inputs to the mix, making this a 14-input console rather than the expected twelve.

The problem arises however when the tape return is used for its intended purpose. The console sends signal to the stereo recorder, and the stereo recorder sends signal back to the console.

But if you were careless enough to press the 'tape return to mix' button, then you would have a positive feedback path and an almighty howlround would result - on your recording!

So here are two very good ways to ruin a perfectly good recording, right where your fingers will be resting much of the time.

One slip and disaster. Fatal to a live recording. Clearly, these buttons should have been in a remote location, perhaps towards the top of the console.

So the 'do not press' message was my warning to myself. And fortunately it worked all the time I had the console. Except the first time my fingers slipped, which was the occasion that prompted the additional caption.

I wonder if any other equipment has a 'do not press' button?

Any offers?

A post by David Mellor
Friday November 11, 2005 ARCHIVE
David Mellor has been creating music and recording in professional and home studios for more than 30 years. This website is all about learning how to improve and have more fun with music and recording. If you enjoy creating music and recording it, then you're definitely in the right place :-)
Come on the FREE COURSE TOUR