Special enrollment Monday May 1 to Friday May 5, 2017

Equipping Your Home Recording Studio - A Free Guide from Audio Masterclass

An Introduction to Compression: Basic Compression - A Free Guide from Audio Masterclass

An Introduction to Equalization - A Free Guide from Audio Masterclass

Compressor and gate together

A post by David Mellor
Friday March 07, 2003
Whether to use the noise gate before the compressor, or the compressor before the noise gate.
Compressor and gate together

The gate is often thought of as a companion to a compressor.

Compression always has the effect of increasing the noise level. This is because the peaks of the signal are brought down in level, bringing them closer to the noise floor. Then make-up gain is applied to bring the overall signal level back up again, raising the noise floor at the same time.

Even if there were such a thing as a perfect compressor, this would still happen.

The obvious answer is to use a noise gate to remove the noise, providing the signal meets the criteria for gating as outlined above.

There are two schools of thought among engineers as to how the two should be connected:

  • Some think that it is better to put the gate after the compressor, since the compressor will generate some noise itself, in addition to the noise emphasized by the compression process.
  • Other engineers will say that since the signal has a greater dynamic range before compression, it is easier to set up the gate for reliable triggering if it comes before the compressor.
A post by David Mellor
Friday March 07, 2003 ARCHIVE
David Mellor has been creating music and recording in professional and home studios for more than 30 years. This website is all about learning how to improve and have more fun with music and recording. If you enjoy creating music and recording it, then you're definitely in the right place :-)