Special enrollment Monday May 1 to Friday May 5, 2017

Equipping Your Home Recording Studio - A Free Guide from Audio Masterclass

An Introduction to Compression: Basic Compression - A Free Guide from Audio Masterclass

An Introduction to Equalization - A Free Guide from Audio Masterclass

Can you use XLR connectors for stereo signals?

A post by David Mellor
Monday June 19, 2006
A typical XLR connector has enough pins to carry a stereo signal. So is this a good idea, or is there a better solution?
Can you use XLR connectors for stereo signals?

The XLR connector is one of the great successes of audio. Doubtless modern science and technology could find a better solution, but the XLR doesn't have many problems, and you can use equipment with XLR connectors anywhere.

If you look at a typical XLR connector, you will see three pins or sockets, depending on whether it is a male or female connector. So you might wonder whether you could possibly run a stereo signal along one cable. After all, it would halve the number of cables, wouldn't it?

Well you can do this, but it's not ideal. The reason why it is not ideal is that the XLR connector, also the cable to which it is attached, is designed to carry a balanced signal. This requires two conductors for the signal, plus the earth. Balanced signals reject interference better than unbalanced signals.

So if you did want to use an XLR cable for stereo, then you would have to run unbalanced signals. You can share the earth between the two channels with no problem. This arrangement actually works very well for headphones - better than jacks for this purpose in the studio.

So the recommendation is really not to use XLR connectors for stereo signals, unless it is for a special one-off purpose where the lack of balancing doesn't matter, and the convenience factor outweighs anything else.

In fact there are such things as 5-pin XLR connectors. The pins are always numbered and are connected as follows:

  1. Screen/earth
  2. Left channel hot
  3. Left channel cold
  4. Right channel hot
  5. Right channel cold

Of course you will also need a cable with five conductors and a screen.

A post by David Mellor
Monday June 19, 2006 ARCHIVE
David Mellor has been creating music and recording in professional and home studios for more than 30 years. This website is all about learning how to improve and have more fun with music and recording. If you enjoy creating music and recording it, then you're definitely in the right place :-)